MAIN Use this menu to make changes to the basic system configuration. Doing so may damage the motherboard. Second] Set the system to the time that you specify. This allows the user to set CPU host frequency manually. To access the menu bar items, press the right or left arrow key on the keyboard until the desired item is highlighted. Connect the fan cable to the connector matching the black wire to the ground pin.

Uploader: Vihn
Date Added: 7 February 2005
File Size: 27.55 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64011
Price: Free* [*Free Regsitration Required]

Installation of Heatsink and CPU fan Remove the system unit cover if your motherboard is already in stalled in a chassis. Before you install or remove any component, ensure that the power is switched off or the power cord is detached from the power supply.

Gentoo Forums :: View topic – TIP: sound with ASROCK K7VT2 or similar (via82xx)

Chapter 1 and 2 of this manual contain introduction of the motherboard and step-by-step installation guide for new DIY system builders. Also, for proper operation, it is not recommended to use asrocm different brands of the DIMMs at the same time.

This automatically activates the Numeric Lock function after boot asrck. Please make sure to disconnect power supply before adding or removing DIMMs or the system components.

  MURATEC F 525 DRIVER DOWNLOAD

Replace the system cover. Step 1 Step 2, 3 Step 4 2. Use keys to move between the Hour, Minute and Second fields.

ASRock K7VT2 – motherboard – ATX – Socket A – KT266A

Connector FDD connector pin floppy see p. Before attempting to configure a hard disk drive, make sure you have the correct configuration information supplied by the drive manufacturer. This loads the default values for all setup options. The default is 4X. Because motherboard settings and hardware options vary, use the setup procedures in this chapter for general reference only.

Select mode for the IR transmission port. To avoid damaging the motherboard components due to static electricity, NEVER place your motherboard directly on the carpet or the like.

ASRock K7VT2 – motherboard – ATX – Socket A – KTA Overview – CNET

This allows the user to select the value as operating frequency. Unlock a DIMM slot by pressing the retaining clips outward. The following table lists the keys found in the legend bar with their corresponding functions.

The motherboard detects the jumper setup and sets the CPU host frequency automatically. To access the menu bar items, press the right or left arrow key on the keyboard until the desired item is highlighted.

MAIN Use ,7vt2 menu to make changes to the basic system configuration. Refer to the drive documentation to determine the correct values. It refers to a section of the PCI memory address range used for graphics memory. With respect to the contents of this ,7vt2, ASRock does not provide warranty of any kind, either expressed or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose.

  DIGI VIEW K11 DRIVER

Please check if the CPU fan on the motherboard functions properly before you resume the system.

All changes are discarded. DO NOT place jumper caps over these connectors.

This allows the user to set CPU host frequency manually. If automatic detection is successful, BIOS Setup automatically fills in the correct values for the remaining fields on this sub-menu. ATX form factor 12″ x 9. Failure to do so may ,7vt2 physical injuries to you and damages to motherboard components. If automatic detection fails, this may due to the hard disk is too old or too new.

Second] Set kk7vt2 system to the time that you specify.